(154) 154 product ratings - 2 x LP-E6N Battery For Canon EOS 5D Mark II 70D 60D 60Da LP-E6 Mark III 5D 6D. Louis ) pic hide this posting restore restore this posting. Possible, keep your answers simple enough or detailed enough for those of us to The Canon EOS 60Da should go on sale later this month, with only limited numbers available from select dealers. Is this possible with either of the above two Through whatever ASCOM connection I end up with. Would like to do plate solving using Astro-Tortilla through Backyard EOS On top of this, I use Backyard EOS to control my camera and Is there a way to keep the hand controlįunctional and still have PHD2 communicate with my mount through this cable? If this method will work, should I remove theĬable from the Starshoot Autoguider to the Auto-Guide jack on my mount?
#Backyardeos 60da usb hub software
The NexRemote software which makes the hand controller non-functional. Is this now an ASCOM connection? Same question about the Aux Mount selection
The controller then goes to the Hand Control jack in the mount. If the above cable is only for ST4 connections, I have theĬonnector to go from a USB out of my laptop to an RS232 to the jack thatĬonnects at the bottom of my hand controller. Telescope chooser, Generic hub, Pipe diagnostic tool, POTH hub, Simulator or Monoprice 15-Feet USB 2.0 A Male to Mini-B 5pin Male 28/24AWG Cable with Ferrite Core (Gold Plated) (105450) Connect your devices with USB mini B connector using this USB 2.0 A Male to USB Mini-B Male Cable from Monoprice This cable features a standard USB A male connector on one end and a 5-pin mini B connector on the other. Supposed to “Use ASCOM for the PHD2 ‘Aux Mount’ connection”. Does this make this an ASCOM connection? In the equipment setup section of PHD2 I’m
#Backyardeos 60da usb hub drivers
I have loaded the ASCOM drivers on my laptop. I have a Celestron CGEM DX, and am using an Orion Starshootįrom the autoguider to the Auto-Guide jack on my mount is an ST4 connection(Im not sure).
0 kommentar(er)
